Does water get through heavy grade weed barrier?

Yes. The non-woven layer acts as a filtration barrier, letting moisture and airflow reach the soil while blocking weed germination at the source. That is the advantage over plastic sheeting, which blocks water entirely.

What are the planting stripes for?

Layout. The woven face carries printed stripes at 12 inch intervals, so rows and plant spacing come off the fabric rather than a tape measure.

How much heavy grade weed barrier do I need?

All five widths are on 250 foot rolls: 1,000 square feet for the 4 foot, 1,250 for the 5 foot, 1,500 for the 6 foot, 2,000 for the 8 foot and 3,000 for the 12 foot. Allow extra for the 4 to 6 inch overlap between runs.

How much overlap does weed barrier fabric need?

4 to 6 inches where runs meet. Overlap rather than butting the edges, because a joint that opens is a direct route to daylight for whatever is underneath.

Does weed barrier fabric have to be covered with mulch?

It is recommended. Finish with 3 to 4 inches of bark, mulch or stone, which protects the fabric from ultraviolet light and gives the project a finished look.

Weed Barrier Fabric - Heavy Grade - 5oz - 8' x 250' Roll

Heavy grade weed barrier fabric on a sloped bed with boulders and mulch above a block retaining wall

Heavy grade weed barrier fabric covering a sloped planting bed above a stone retaining wall

Weed barrier fabric laid in a residential front yard bed with trees, shrubs, and mulch piles ready to spread

Heavy grade weed barrier fabric installed in a foundation planting bed with shrubs and mulch half-spread

Weed barrier fabric installed in a curved front yard garden bed lined with stone edging and flowering shrubs

Weed barrier fabric installed in a commercial landscape bed with trees and river rock border outside an office building

Weed barrier fabric laid along a backyard fence-line planting bed with trees, shrubs, and a mulch wheelbarrow

Finished Weed Barrier Installation in Landscaped Backyard

Weed Barrier Fabric - Heavy Grade - 5oz - 8' x 250' Roll

Q: What makes heavy grade different from standard weed barrier?

Construction and weight. This is two fabrics in one, woven for strength and non-woven for permeability, at 5 oz. A standard barrier is a single material and lighter, so it either tears more easily or lets weed roots probe through the weave over time.

Q: Will weed barrier fabric stop weeds completely?

It blocks germination beneath it, which handles weeds coming up through the soil. Seeds that land in the mulch on top can still root in that layer, so an occasional pull is normal. A pre-emergent herbicide before laying the fabric increases protection.

Q: Can heavy grade weed barrier be used under river rock?

Yes. Angular stone is what punctures lightweight fabric during installation, often before the bed is even finished, so heavy grade is the safer specification.

SKU FPPV08250

$553.25 - $553.25

$553.25

$553.25 - $553.25

$553.25

Free Shipping

Weed Barrier · Heavy Grade · 5 oz Hybrid · 8′ × 250′

Heavy grade weed barrier fabric on an 8′ × 250′ roll covering 2,000 square feet. An eight-foot width for wide beds and commercial planting areas. Two fabrics bonded together — a woven for strength and a non-woven that still lets water through — with a fuzzy face that holds mulch in place and 12″ stripes printed across it to space your plants by.

Roll Size: 8′ × 250′2,000 sq ft per roll
Construction: HybridTwo bonded fabrics
Weight: 5 ozWoven + non-woven
Planting Stripes: 12″Printed on the woven face

Woven strength, non-woven flow
Fuzzy face stabilizes mulch
12″ planting stripes
Contractor grade & UV resistant
Free shipping on all orders

Free Shipping - Please submit a Quote Request for quantities larger than listed below.

Quantity	Price Per Unit (Free Shipping)
1	$553.25
2+	$525.59
3+	$497.93
10+	$470.26

01 Hybrid construction · 5 oz

Weed Barrier Fabric — Heavy Grade

When you want a thick, strong fabric that gives dependable weed control, this is it. This heavy grade weed barrier fabric is constructed of both woven and non-woven fabrics, which gives it the high strength of a woven with the permeability of a non-woven — two properties that normally force a compromise.

At 5 oz it is heavier than the hybrid fabrics usually sold under this description, and it is built for the jobs where a standard weed barrier gets shredded, punctured or simply grown through.

2fabrics bonded into one

Woven for strength, non-woven for permeability — you normally have to choose.

02 The trade-off it removes

Strength Or Flow. Usually Not Both.

A woven weed barrier is strong but passes water only through the gaps in the weave — and those same gaps are where weed roots eventually probe through. A non-woven passes water freely but tears. Bonding the two means moisture and air reach the soil while weed germination is blocked at the source, in a fabric that survives being walked on.

03 Worth knowing before you lay it

The Two Sides Do Different Jobs

This is not a symmetrical fabric, and knowing which face goes up changes how well it performs.

Side	Texture	What it does
Woven face	Smooth, with printed 12″ planting stripes	Carries the strength. The stripes let you lay out rows and plant spacing off the fabric instead of measuring.
Non-woven face	Fuzzy, textured	Grips and stabilizes. Holds against the soil so the fabric does not shift while you work, and anchors mulch on top against wind and rain.

The fuzzy side is the reason mulch stays put. On a slope or an exposed bed, mulch sliding off a slick fabric is a recurring maintenance job. A textured face gives it something to key into, which is a practical advantage a single-sided fabric simply cannot offer.

04 What you get

Benefits

Thick, strong fabric giving dependable weed control
Constructed of both woven and non-woven fabrics — strength plus permeability
Significantly more puncture and tear resistant than single-material alternatives
Fuzzy textured side stabilizes mulch and grips the soil
Planting stripes at 12″ spacing for convenient, precise layout
Moisture and airflow reach the plants while weed germination is blocked
Contractor grade and UV resistant
Non-biodegradable — will not rot or mildew, and resistant to rodent and insect damage

Why 5 oz matters. Weed barrier is usually specified light because it is going to be buried under mulch and forgotten. The failures happen at the exceptions — where it is walked on, where sharp stone sits on it, and where a heavy weed pushes at it for a season. Weight is what handles those.

05 Sizing

Available Roll Widths

Five widths, all on 250-foot rolls and all the same 5 oz fabric. Match the width to the bed and you cut seams, offcuts and labor together.

4′1,000 sq ft 5′1,250 sq ft 6′1,500 sq ft 8′2,000 sq ft 12′3,000 sq ft

Part number	Roll size	Sq ft	Best for
FPPV04250	4′ × 250′	1,000	Borders, foundation beds and narrow runs — easiest to handle alone
FPPV05250	5′ × 250′	1,250	A slightly wider bed in a single pass
FPPV06250	6′ × 250′	1,500	Standard landscape beds and pathways
FPPV08250	8′ × 250′	2,000	Wide beds and commercial planting areas
FPPV12250	12′ × 250′	3,000	The widest roll — large open areas with the fewest seams

06 Where it goes

Applications

Landscape beds Commercial landscaping Under river rock & stone Under bark & mulch Foundation beds Garden pathways Around shrubs & trees Retaining wall beds Outdoor nursery areas Raised bed surrounds Woodland paths Slopes & banks

Stone beds are where heavy grade earns its keep. River rock and crushed stone are exactly the conditions that puncture a lightweight fabric during installation, and the damage is done before the bed is even finished.

07 Installation

Three Steps

Prepare the area. Remove all weeds and plants from the area. For increased protection, consider applying a pre-emergent herbicide before laying the fabric down.
Lay, cut and pin. Unroll and cut the fabric to length. If overlapping, allow a 4″–6″ overlap. Cut an X slit where each plant will go. Secure with fabric staples, staggered at approximately one staple per 5 feet.
Cover it. Finish with 3–4 inches of bark, mulch or stone to protect the fabric from ultraviolet light and give the project a finished look.

Cover it, even though it is UV resistant. The 3–4 inch mulch or stone layer is not just cosmetic — UV is what ages an exposed fabric, and a covered barrier keeps working far longer than one left bare in a bed.

08 You will also need

6″ Landscape Staples

The install calls for staples staggered at roughly one per 5 feet, along every edge, at every overlap and anywhere the fabric lifts. That is what keeps it flat against the soil while you spread mulch over it.

6″ landscape staples are the standard pin for this fabric, and they are sold separately — worth adding to the order rather than discovering the gap on install day.

View 6″ Landscape Staples

09 Documentation

Specification Sheet

Heavy grade weed barrier specification sheetPDF

10 Buying from us

Why Buy Weed Barrier Fabric From Landscape Discount

Contractor grade only

Professional-grade fabric designed for residential and commercial use alike. We never substitute another fabric or weight without the explicit consent of the customer.

Free shipping, every order

On every width and every quantity, with no threshold to reach and no freight surprise at checkout.

Five widths, one fabric

4′ through 12′ on 250-foot rolls, so the roll matches the bed rather than leaving you to seam and offcut around it.

We answer the phone

When you call you quickly reach a helpful, live person happy to answer your product and order questions. (M-F 5:00 am - 3:00 pm Pacific Time)

11 Common questions

Heavy Grade Weed Barrier FAQs

Which side goes up?

The smooth woven face with the printed planting stripes goes up; the fuzzy non-woven face goes down against the soil. The textured side grips the ground so the fabric does not shift while you work, and it also helps anchor mulch spread over the top.

What makes this different from a standard weed barrier?

Construction and weight. This is two fabrics in one — woven for strength, non-woven for permeability — at 5 oz. A standard barrier is a single material and lighter, so it either tears more easily or lets weed roots probe through the weave over time.

Does water get through it?

Yes. The non-woven layer acts as a filtration barrier, letting moisture and airflow reach the soil and the plant roots while blocking weed germination at the source. That is the advantage over plastic sheeting, which blocks water entirely.

What are the stripes for?

Layout. The woven face carries printed stripes at 12″ intervals, so rows and plant spacing come off the fabric rather than a tape measure. On a commercial bed or a long run that is most of the setting-out time saved.

How much fabric do I need?

All five widths are on 250-foot rolls: 1,000 sq ft for the 4′, 1,250 for the 5′, 1,500 for the 6′, 2,000 for the 8′ and 3,000 for the 12′. Allow extra for the 4″–6″ overlap between runs.

How much overlap do I need?

4 to 6 inches where runs meet. Overlap rather than butting the edges — a joint that opens is a direct route to daylight for whatever is underneath.

How many staples?

Stagger them at approximately one staple per 5 feet, along every edge, at every overlap and anywhere the fabric lifts. 6″ landscape staples are the standard pin and are sold separately.

Do I have to cover it with mulch?

It is recommended. Finish with 3 to 4 inches of bark, mulch or stone. That protects the fabric from ultraviolet light and gives the project a finished look — UV is what ages an exposed fabric fastest.

Will it stop weeds completely?

It blocks germination beneath it, which handles the weeds coming up through the soil. Seeds that land in the mulch on top can still root in that layer, so an occasional pull is normal. A pre-emergent herbicide before laying the fabric increases protection further.

Can I use it under river rock?

Yes, and that is one of the better reasons to choose heavy grade. Angular stone is what punctures lightweight fabric during installation, often before the bed is even finished.

What does shipping cost?

Nothing. Shipping is free on every order, at any quantity.